- QuickLabel Systems Thermal Transfer Printer Operation & Setup Guide

4-38 Keypad controls and menus
RS232 Baud Rate
If you are using the RS232 serial port connection, you can configure the
printer to use one of four specific baud rates.
To select a baud rate:
1 If the printer is in a Ready state, press the PRINT/PAUSE key to pause
the printer.
2 Press the NEXT or PREVIOUS key until the Communications menu is
displayed. Then press the SELECT key.
3 Press the NEXT or PREVIOUS key until the RS232 Baud Rate menu is
displayed.
4 Press the + or – key until the desired baud rate is displayed. Available
options are 4800, 9600, 19200, or 38400.
5 Press the SELECT key to confirm your baud rate choice.
RS232 Baud Rate
19200
Pause: Communications
Press SELECT