- QuickLabel Systems Thermal Transfer Printer Operation & Setup Guide

4-28 Keypad controls and menus
4 Press the SELECT key. A message will be displayed to confirm Pull Back
operation.
5 Press the SELECT key.
The printer will begin rewinding media until the last unprinted label is
positioned just behind the media sensor.
If a Pull Back operation has been requested and a print batch has not
been sent to the printer or the media has been moved in any way (i.e.
Form Feed, Calibrate, Test Print, etc.) the following error message will be
displayed.
To activate media pull back with the FORM FEED button:
1 While the printer is in a Ready state, press the FORM FEED key.
The printer will begin rewinding media until the last unprinted label is
positioned just behind the media sensor.
If a Pull Back operation has been requested and a print batch has not
been sent to the printer or the media has been moved in any way (i.e.
Form Feed, Calibrate, Test Print, etc.) the following error message will be
displayed.
Note: The FORM FEED key will activate the pull back feature only when
the printer is in the Ready state. If the printer is paused, the FORM FEED
key will operate normally, advancing the media when pressed.
Pull Back Off
Media Moved / No Batch
Pull Back Off
Media Moved / No Batch
Pull Back
SELECT to confirm