User guide

Copying

Phaser 6121MFP Multifunction Printer

User Guide

Manual 2-sided Copying from the Auto Document Feeder

You can copy a stack of 2-sided pages from the auto document feeder using the following method.

To print 2-sided to 2-sided using the auto document feeder:

1. Place the stack of originals in the auto document feeder and then press the Copy button.

2. After copying, remove the originals from the auto document feeder output tray and flip the stack

over and place it back into the auto document feeder, being careful not to disturb the page order.

3. Remove the printed copies from the output tray and, keeping them together, insert them top first,

blank side facing up, into Tray 1 (this rotates the pages 180 degrees from the way they printed out

into the output tray).

4. Press the appropriate Start button to copy the other side of the stack in the auto document feeder.

2-sided Copying from the Document Glass

To create 2-sided copies:

1. Position the first side (or first page) of the document facedown on the document glass. (For details,

see Basic Copying on page 76.)

2. On the printer control panel, press the Copy button.

3. Select the paper source tray and any image adjustments desired. See Adjusting Copy Options on

page 78 for details.

4. Press the Down Arrow button to go to Sides and then press the OK button.

Note: The Sides (Duplex) function may be set to Off, but that will change when you select 2-sided

copying options.

5. Press the Down Arrow button to select 1 > 2 and then press OK.

6. Select the orientation (binding or “flip” side) for the second page:

•Short Edge Flip

• Long Edge Flip

7. Press OK.

If Long Edge Flip is selected, the pages will be printed to flip on the long edge of the

paper.

If Short Edge Flip is selected, the pages will be printed to flip on the short edge of the

paper.