User guide

Installation and Setup
Phaser 6121MFP Multifunction Printer
User Guide
31
Setup Checklist
Setup steps for the printer configuration types are given individually below. If you are not sure of your
printer configuration type, look on the printer control panel. If you do not have fax buttons on the left
side (Auto RX, Address Book, etc.), then you have the Phaser 6121MFP/S printer configuration.
Phaser 6121MFP/S Printer Configuration
1. Unpack the printer, remove all packing tape from the outside and inside of the printer, then attach
any parts that were packed separately from the main printer body. See the Installation Guide for
details.
2. Select a location for the printer. See Choosing a Location for the Printer on page 33.
3. Connect the printer to your computer using a USB cable and then connect the power cord. See
Connecting the Printer on page 34.
4. Turn the printer on.
5. Load paper into Tray 1. See step #10 of the Installation Guide that came in the setup packet with
the printer.
6. Perform the initial setup at the printer control panel. See Configuring the Phaser 6121MFP/S on
page 35.
7. Check your operating system requirements. See Operating System Requirements on page 38.
8. Windows users, install the drivers and the Scan Dashboard utility. See Installing the Drivers for the
Phaser 6121MFP/S on page 41. Once you have installed the drivers, you are done with the
software installation.
9. Macintosh users, install the printer driver and the scan driver. See Installing the Drivers for
Macintosh on page 43.
10. Macintosh users, add the printer. See Adding the Printer for Macintosh on page 44.