User guide
Troubleshooting
Phaser 6121MFP Multifunction Printer
User Guide
182
Remove original
in document feeder
The document is loaded in the auto
document feeder while a function is
set that requires scanning from the
document glass.
Remove the document from the auto
document feeder and place the
document on the document glass.
Results are over (xxx) The LDAP search results exceed the
maximum specified with Max.
Search Results in the LDAP Setting
menu.
Change the maximum setting, or
change the search conditions (for
example, increase the length of the
search word), and then try performing
the LDAP search again.
Reload (xxx) original
into document feeder
and press Start key
After a paper jam has been cleared
from the auto document feeder, the
number of document pages to be
reloaded into the auto document
feeder is indicated.
Reload into the auto document feeder
the number of document pages
indicated by (xxx) and then press the
Start button.
Memory full
at SMTP Server
The memory of the SMTP server has
become full.
Free up some space on the disk. If
necessary, contact your SMTP server
administrator.
Recipient memory is
full, cannot accept
fax or Email
The maximum number of 236
destinations for the scan data has
been reached.
Send the data and then try scanning
again. Otherwise, delete unnecessary
destinations before adding the desired
ones.
Toner l ife end
Replace (CMYK) toner
The indicated toner cartridge has
become empty.
Replace the indicated toner cartridge.
Toner empty
Replace (CMYK) toner
The indicated toner cartridge has
become empty. (This message
appears if Toner Out Action in the
General Setup menu is set to Stop
All.)
Toner Low (xx) The indicated toner cartridge is
nearly empty.
Prepare the indicated toner cartridge.
Tray 2 open
Close Tray 2
Tray 2 cassette is open. Close the tray by properly inserting and
seating the tray in the printer.
Toner Memory Error A memory error occurred in the
toner cartridge.
Re-install the specified toner cartridge.
USB Dev. Not support A USB device incompatible with this
printer is connected.
Disconnect the USB flash drive from this
printer and try a different USB device.
USB Hub Not support A USB hub is connected to this
printer.
This printer is not compatible with a
USB hub. When connecting USB cables
to this printer, do not use a USB hub.
USB memory full There is no space available on the
USB memory device connected to
this printer.
Delete data from the USB flash drive to
create free space, or use a different USB
flash drive.
Message Reason Action