Administrator's Guide
Table Of Contents
- Contents
- Introduction
- Machine Connection
- Network Installation
- Printer Drivers
- Network Accounting
- Security
- SMart eSolutions
- CentreWare Internet Services
- Software Upgrade
- Troubleshooting
- Appendix
- Index
Software Upgrade
Phaser 4622
System Administrator Guide
132
Procedure
1. At your Workstation, open the web browser, enter the IP Address of the machine in the Address
bar.
2. Press Enter.
3. Click on the Properties tab.
4. Click on Maintenance link.
5. Click on Firmware Upgrade link.
6. Click on Enabled.
7. Click on Firmware Upgrade. If prompted, enter the Administrator’s User ID admin and Password
1111, and click Login.
8. In the Firmware Upgrade box, click on Browse to locate the software upgrade file .hd obtained
earlier.
9. Click on the .hd file.
10. Click on the Open button.
11. Click on the Install Software button to proceed with the upgrade.
If prompted, enter the Administrator’s User ID admin and Password 1111, and click Login.
12. The file will be sent to the printer and will disable the printing functionality. The web browser will
become inactive and you will not be able to access the machine via this method until the upgrade
has completed and the machine has rebooted. The upgrade should take no longer than 30
minutes.
13. Once the machine has completed the upgrade it will reboot automatically. The configuration
report will print (if enabled). Check the configuration report to verify that the software level has
changed.