Operation Manual

54 ¦ Settings · Setting the Fax Switch
EN
Adjusting Volume Level
Setting the Ring Tone Volume
You can adjust the volume of the ring tone when the device is ringing or when you set the
ring tone. You can save different volumes for the
™ (day) and ˜ (night) modes, (also see
Chapter Fax Switch).
Setting the Volume on the Device
Using [ you can set adjust the volume when the device is ringing.
Setting the Fax Switch
Fax Swit ch
The built-in fax switch of your device distinguishes between fax messages and telephone
calls. Faxes are automatically received, telephone calls can be received—even on additionally
connected devices. While the device is checking the call, it continues to ring.
Day and Night Mode
You can set how often the device should ring before picking up separately for the modes ™
(day) and ˜ (night). This makes it possible for you to receive faxes silently at night without
getting disturbed.
Press º/» to switch between day and night mode. With the activated timer
›, the device
switches between the modes
™ (day) and ˜ (night) at the configured times.
Setting the Day Mode
1. Press OK, 51 and OK.
2. Use [ to select the total number of rings. The device stops the ring after these total
number of rings and accepts a call or a possible silent fax.
3. Confirm with OK.
4. Use [ to select the number of rings for the fax switch. After the number of rings, the
fax switch switches on and distinguishes between fax transmissions and telephone calls.
While the device is checking the call, it continues to ring.
5. Confirm with OK.
6. Using [, set the volume.
7. Confirm with OK.
Silent Fax Transmission
Setting the Night Mode
1. Press OK, 52 and OK.
2. Configure the same settings as for the day mode (see steps 2 to 7).
Notice
Silent Fax Transmission
Older devices do not transmit any fax-tone (= CNG tone) as an announcement for
fax transmission (= silent fax transmission). If the total number of rings has been set
to a value using
7, silent fax transmissions cannot be received automatically.