User's Manual

4
Sheet flatness adjustment
(in Printer: Adjust Decurler…)
If the Sheet Enhancement
Module is present
• Flat paper gives best
performance in BFM.
• Use the automatic mode with
it’s default setting.
• Adjust the automatic slider
as needed; positive values
reduce up-curl, negative
values reduce down-curl.
• Use Manual mode only if
automatic mode is still not
providing adequate sheet
flatness.
5
Reduce Up-Curl for 2-Sided
Jobs
(in User Diagnostics: System
Optimizations, not available in
Nuvera Digital Perfecting
System)
• Use only if you experience
excessive Up Curl on 2-sided
jobs and it cannot be reduced
or eliminated with the SEM.
• Turn off to get maximum
output throughput or when
using side-dependent
stocks (letterhead,
carbonless, etc.)
6 Variable Shaped Tray
• Papers less than 140 gsm. • Papers greater than 140
gsm.
• Some papers will run
better without tray
especially if little or no curl
exists.
7
Bindexer Setting
(in Printer Manager: Stacking
tab, right click on a Finisher)
• Lower value for curled sheets.
• Lower value improves
stacking of some papers.
• Improves jam rate with heavy
papers.
• Reduce to 35 for most
problem jobs.
• Adjust if set size is equal to
bindexer plus 1 to 4
sheets. (i.e. If setting is 35
and job is 37 sheets
increase the bindexer to 37
or greater)
8
Improve Set Registration
(in Printer Manager: Stacking
tab, right click on a Finisher)
• When excessive curl is
causing tamping errors in the
compiler
• Staple jobs using 2 staples
with buckle or pucker between
the staples
• Turn off when not required
to maximize BFM
component life and reduce
service
9
Improve Initial Pages
Registration within Set
(in Printer Manager: Stacking
tab, right click on a Finisher)
• Improve performance when
curl exists on paper.
• Productivity is better when
not selected.
37