User's Manual

Xerox Nuvera, iGen Production System Production Media Cart 1
Production Media Cart User Guide
Xerox Production Media
Cart
The Production Media Cart is an optional unit that can interface with certain Xerox stackers to
assist with transporting printed media from the printer stacker to work tables, pallets, or near-
line/offline finishing. The Production Media Cart (Cart) uses a battery powered vertical elevation
system to set the media table height and a hand crank to transfer the paper stack from the
Cart.
Features
Paper stack pickup:
• The stack can be picked up from the Xerox Production Stacker (XPS)
– Stack pickup low elevation: 210 mm (8.26 inches)
– Stack pickup high elevation: 600 mm (23.6 inches)
• The stack can be picked up from the Xerox iGen Stacker
– Stack pickup elevation: 103 mm (4.06 inches)
Note
Xerox Nuvera Media Cart Enabling Kit pre-installation is required.
iGen Pallet Interface Kit pre-installation is required.
iGen Powered Eject Kit pre-installation is required.
Paper stack unload: The stack is delivered intact horizontally to offline devices, such as the
CP Bourg BSFEx Air Table, or transferred to a flat work table or consolidation pallet.
Paper stack clamp: Secures the paper stack to the paper table to maintain stack integrity
during transport.
Locking rear casters: Stabilize the Cart while docked with the stacker or while offloading the
stack.