User's Manual

Xerox Nuvera™ 100/120/144 Digital Production System - Customer Expectations Document
- 31 -
SPECIAL STOCKS
Carbonless
Xerox Carbonless Papers as listed in this document are the only recommended carbonless media. Only
simplex printing is supported on this stock type.
Running carbonless paper may require additional cleaning
time by the CSE during service of the machine. This time will vary based on the percentage of carbonless
stock run. In the 100% carbonless usage case, service time could be up to 60 additional minutes per
service call at 150,000 prints
DocuCards®
DocuCards® can only be loaded 100 at a time in a tray. Nuvera feeder trays feed until almost empty but
not until empty, leaving 20~40 sheets remaining. When running DocuCards®, frequent reloading of the
feeder trays will be required.
DocuCards® can only be run to the Top Tray of the finisher. Some mis-stacking may occur as the
DocuCards® catch on the edges of the stacked sheets®.
When using DocuCards, it is recommended that you use a Tiltatron (available from CAS).
DocuCards are not supported on the Nuvera MX system.
Reinforced stocks
Reinforced stocks such as Mylar tabs should be limited to 90 loaded in a tray
at one time.
Transparencies
The tray capacity for removable stripe transparencies is 90 sheets. There is no
constraint for feeding painted striped transparencies or stripeless
transparencies.
Tab Jobs
Running tabs requires proper use of the supplied Tab Guides.
Jobs should be run with straight collated tabs.
Tab stock sizes supported are: Letter, 9” x 11,” 9.5” x 11”, A4
Envelopes
Envelopes should be limited to 60 loaded in a tray at one time. Nuvera feeder
trays feed until almost empty but not until empty, leaving 20~40 sheets
remaining. When running envelopes frequent reloading of the feeder trays will
be required.
Very slight wrinkles (1/2 inch long) may occur on the trail edge of envelopes at the corners.
Due to the nature of feeding envelopes with flap open, some mis-stacking may occur in the top tray as the
envelopes catch on the open flaps
Envelopes should be sent to the Top Tray only.
Inserter Module (IM)
The specifications for the Inserter Module are the same as for the SFMs. Either the 4-tray SFM or the 2-tray
Large Format SFM can be used as an inserter. One inserter may be installed on the output side of the
printer.
COMMENTS
• LCDS and IPDS applications are currently not able to pull paper stocks from the Insertion Module.
2-Tray LFSFM