User's Manual

Xerox Nuvera™ 100/120/144 Digital Production System - Customer Expectations Document
- 12 -
Product Space & Power Requirements
Item Xerox Nuvera™ 100/120/144
Digital Production System
Comments
Size – Printer w/
1 SFM & FTM
110” (W) X 29 ” (D) X 46.3 ” (H)
2794 mm x 711.2 mm x 1176 mm
Printer Digital Tower 61.6” (1565 mm) (Height)
DFA finishing devices vary by device*.
Size – Printer w/
1 SFM & BFM
108” (W) X 28 ” (D) X 46.3 ” (H)
2741 mm x 711 mm x 1176 mm
Width of
additional SFM
31.7”, 805mm Optional
Width of BFM
Plus
48”, 1220mm Optional, BFM Plus used with BFM (with top
tray) in dual BFM installations.
Service Space 128” (W) x 113” (D)
3251mm x 2870 mm
At least 30” from the wall in rear.
DFA finishing will increase width.
Weight 1545 lb. (701 kg)
Additional SFM – 423 lbs. (192 kg)
With consumables loaded, except media
Power
Requirements
North America
208 Volts / 30 Amp sole use, 60 Hz
Single phase, 3 wire + PE (L1, L2, N,
GND)
• UL & cUL compliant
• Complies with the FEMP (Federal Energy
Management Program) via machine circuit
breaker (CB); with the CB switched off, the
system consumes less than 1 watt.
Power
Requirements
Europe /Japan
200-240 Volts / 25 Amp sole use, 50 Hz
Single phase, 2 wire + PE (L, N, GND)
• Units are compliant with applicable EU
directives and are CE marked
*-Please refer to supported inline DFA finishing devices Solution Planning Guides for Product Space and Power
Requirements.
System Configuration and Installation
Installation Preparation Document
This section should be used in conjunction with the Xerox Nuvera™ 100/120/144 Digital Production
System Installation Planning Guide (IPG), the Xerox Nuvera™ 100/120/144 Digital Production
System Installation Preparation Document (IPD), and the supported inline DFA Finishing Device
Solution Planning Guide, which contain detailed specifications for size, weight, electric, and
environmental conditions. Only the most important requirements are stated here.
Customer Responsibilities
The following must be completed before system delivery and will be assessed in the final site check:
Item Comments
Identify placement of the system
Ensure the printer can be delivered to the
site
Supply the appropriate electrical connections Dedicated power required
Install an exhaust duct to vent hot air to the
air system or the outside if required
Heat vent kit is available. The kit lowers the system’s
output from approximately 18,700 BTU/hour to 8,500
BTU/hr.
Install a network drop for Internet access Automatic upload of data for remote diagnostics
Verify the strength and slope of the floor
Meet room Environmental Specifications for
temperature and relative humidity year round
This is essential to the system’s ability to perform as
expected; Xerox will not be able to resolve
performance problems encountered when the area is
not maintained within this operating range.
Connect system to network including proxy
server information