Printer User Manual

Using the Menu System
Chapter 1: Configuring the Printer ❖ 1-39
Form Length
Set the default text length (number of
lines on a page) used in PCL.
The available values are:
5 - 128
(
60*
when
Defaults
=
Inches
)
(
64*
when
Defaults
=
Millimeters
)
Form Length is automatically adjusted
when Paper Size is changed. The
Form Length is recalculated using the
formula: Form Length = ((page length
in inches - 1 inch) * 6).
The Form Length value changes
incrementally by 1 each time either
Value Up
or
Value Down
is pressed.
Holding down
Value Up
or
Value
Down
causes continuous scrolling
through the Form Length values.
The value of this setting after
performing a Factory Reset depends
on the value of the Default units
(inches, millimeters).
1. Press
Menu Up
or
Menu
Down
until you see:
Menus
PCL Menu
2. Press
Item Up
or
Item Down
until you see:
PCL Menu
Form Length
3. Press
Value Up
or
Value Down
until you see:
Form Length =
New Value
4. Press
Enter
. You will see:
PCL Menu
Form Length
5. Press
Online
. You will see:
Ready
Table 1.13 PCL Menu Functions
(continued)
Menu Item and Function Keystrokes Display Reads
Table1.13 Page5 of 6