Printer User Manual

Duplex Unit
6-36 ❖ System Administrator Guide
4
Lift the duplex unit towards you and free its two stubs
from the printer.
5
Remove the duplex unit from the printer.
Be careful not to touch the fuser. It becomes
very hot from printing.
6
Reinstall the side cover by (1) lining up the tab,
(2) pushing up, (3) while pushing in, and (4) sliding it
into place.
7
Close the rear cover.
8
Reconnect the printer’s power cord and power on the
printer.
9
Check the Control Panel display. When the printer has
completed its power on diagnostics, the display should
show
Ready
. If an error message is displayed, refer to Table
5.1 on page 5-5 for instructions.
2
1
3
4