Printer User Manual

Control Panel Messages
Chapter 5: Troubleshooting ❖ 5-7
Flushing
Job name
The printer has discovered a fatal error in a print job and is flushing the
remainder of that job.
Format Failed
Disk Locked
The printer cannot format the disk because the disk has been locked via a
PJL or SNMP command.
Fuser Failure
Power Off/On
The fuser assembly has failed or is not installed. Printing cannot resume.
Power off and power on the printer. If the problem persists, contact your
Customer Service Center.
Init Failed
Disk Locked
The printer cannot put the disk in factory default condition because an
attempt has been made to initialize the disk after it has been locked via a
PJL or SNMP command.
Initializing
Please wait until the printer completes powering up and initializing to
print.
Initializing…
Flash Memory
The printer is initializing the flash memory.
Insert MBF
The printer cannot feed from the multi bypass feeder because it is not set
normally or is not in position. Insert the multi bypass feeder tray to resume
printing.
Insert Tray 1
The printer cannot feed from Tray 1 because the tray is open or removed.
Reinstall/insert the tray to resume printing.
Table 5.1 Control Panel Messages
(continued)
Message Explanation/Corrective Action
Table 5.1 Page 3 of 10