Printer User Manual

Configuring Custom Paper Sizes
Chapter 1: Configuring the Printer ❖ 1-125
Table 1.36 Custom Paper Size Examples.
Custom
Paper Size
Desired
Input Source
Required Steps
8 x 10 in. Tray 1 1. In the application, format the page for Letter size paper, setting the
margins to correctly position the image on 8 x 10 in. paper if
overlaid by Letter size paper.
2. Load the 8 x 10 paper in Tray 1.
3. Set the Tray Menu
Tray 1 Mode
item to
Custom
.
4. Set the
Custom Size
item to
Letter(8.5x11)
.
5. Set the
Tray Sequence
item to a value that does not include Tray 1
(or set to Off).
6. Request Tray 1 as the paper source and send the print job.
6 x 7 in. multi bypass
feeder
1. In the application, format the page for Letter size paper, setting the
margins to correctly position the image on 6 x 7 in. paper if overlaid
by Letter size paper.
2. Load the 6 x 7 in paper in Tray 1.
3. Set the Tray Menu
MBF Size
item to
Custom
.
4. Set the
Custom Size
item to
Letter (8.5x11”)
.
5. Set the
Tray Sequence
item to a value that does not include MBF
(or set to Off).
6. Request MBF as the paper source and send the print job.
8.5 x 11 in.
Short Edge
Feed (SEF)
Tray 1
1. In the application, format the page for Folio size paper (because Folio
is a short-edge feed size on this printer), setting the margins to
correctly position the image on the 11 inches to be used by this
paper.
2. Load the 8.5 x 11” paper into Tray 1 in the SEF direction. This
requires a Ledger/A3 size tray. The paper length guide will be set to
11 inches, rather than the width guide. (Set the width guide to 8.5”.)
3. Set the Tray Menu
Tray 1 Mode
to Custom.
4. Set the
Custom Size
to Folio (8.5 x13”).
5. Set the
Tray Sequence
item to value that does not include Tray 1 (or
set to Off).
6. Request
Tray 1
as the paper source and send the print job.