Laser Printing System Message Guide

IFU (INTERPRESS FONT UTILITY) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 5-39
IF9000 **- DEVICE IS NOT READY -**
The medium specified was not available when the operation was
attempted, or during the operation.
Action 1. Prepare the medium for operation and retry the command.
2. If the retry fails, replace the media and retry.
IF9001 **- END OF FILE HAS BEEN DETECTED -**
An end of file (tape mark) has been encountered.
Action None.
IF9002 **- END OF VOLUME HAS BEEN DETECTED -**
The logical end of volume was detected during the task execution.
The tape is left positioned between the two tape marks. (This
condition is not detected during the read operations.)
Action Reposition the medium to the beginning of where the WRITE
operation should start and retry the operation.
IF9003 **- DEVICE IS FULL (FCP) -**
This message indicates an attempt to write to a medium that is full.
Action None.
IF9004 **- NO SUCH FILE -**
The file being accessed does not exist.
Action None.
IF9005 **- FATAL HARDWARE ERROR -**
A fatal and unrecoverable hardware error has occurred during the
operation. For example, a bad block detected on the medium is being
used.
Action Contact your systems specialist or Xerox Customer Service.
IF9006 **- FATAL DEVICE ERROR -**
A serious error has occurred on the medium.
Action 1. Select the abort option when the display prompts you to choose
retry, ignore, or abort.
2. Contact your systems specialist or Xerox Customer Service.
IF9007 **- TAPE UNIT IS offline-**
The magnetic or cartridge tape is not online.
Action 1. Place the magnetic medium in the online operating mode.
2. Retry the job.