Laser Printing System Message Guide

IFU (INTERPRESS FONT UTILITY) MESSAGES
5-24 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
IF2973 No valid characters were found in character set x
In processing the FIS master, the substitute character’s raster bitmap
is either missing or defective.
Action 1. Correct the CHARS parameter of the font profile.
2. Reenter the ADD command.
IF2974 Character x is in the system reserved area
No characters may be added in the range 0-208 or 0-20 (octal).
These positions are reserved for system use.
Action 1. Remove the invalid characters from the CHARS parameter in
the font profile.
2. Reenter the ADD command.
IF2975 Contour fonts require RIP option; aborting ADD
The FIS master contains contour character shapes which require the
RIP option.
Action None.
IF2976 Some parameter(s) are not in easy values.
One or more of the parameters specified in the font profile do not
match the easy values of the FIS font master.
Action 1. Correct the font profile to match the easy values.
2. Reenter the ADD command.
IF2979 Invalid DCALSO parameter.
The DCALSO (DATA CENTER ALSO) parameter specified in the
font profile is incorrect.
Action 1. Change the DCALSO parameter in the font profile to YES or
NO.
2. Retry the ADD command.
IF4010 Easy values are missing point sizes or orientations
The FIS master is incorrectly formatted and, therefore, does not
specify point sizes and orientation.
Action None.
IF4110 FIS master error; aborting ADD
Due to an error in the FIS master, the requested ADD command is
being aborted.
Action 1. Obtain a valid FIS master.
2. Retry the command.