Laser Printing System Message Guide

HIP (HOST INTERFACE PROCESSOR) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 4-13
HP2344 Cannot change: job does not exist.
The jid specified does not exist in the HIP job queue.
Action None.
HP2345 Cannot change: output file already exists
The file specified is already resident on the disk.
Action Rename the output file and retry the CHANGE command.
HP2346 Command not allowed on system UI.
This message is in response to a service-oriented command which
creates a display that the system PC-UI is not capable of handling.
Action Use a LINK terminal to execute this command.
HP2400 HIP interface must be offline. Enter ‘HIP OFF’
The HIP DIAGNOSTIC command was entered. HIP must be offline
to perform diagnostics.
Action 1. Enter the HIP OFFLINE command.
2. Reenter HIP DIAGNOSTIC.
HP2410 Abort current transmission; confirm with ‘Y’
This message is a confirmation prompt appearing after the HIP
ABORT command was entered.
Action 1. Enter Y to abort the job
or
2. Enter N if abort is not desired.
HP2420 Defer hip diagnostic until OCS queue idle
The HIP DIAGNOSTIC command was entered while a job was
queued or being processed. The command is being ignored.
Action 1. Wait until all jobs print.
or
2. Enter the ABORT job command to cancel the job (if only one
remains).
or
3. Enter the RESET command to delete all jobs.
4. Reenter the HIP DIAGNOSTIC command to proceed with
diagnostics.