Laser Printing System Message Guide

HIP (HOST INTERFACE PROCESSOR) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 4-9
HP1420 End of test 3 analysis
The system failed Diagnostic Test 3. HIP has completed analysis of
Test 3 results and has identified the data line that has failed. This
message follows message HP9431 or HP9432.
Action None.
HP2010 No host selected
A host has not been selected for HIP.
Action Enter the appropriate HIPHOST command. (Refer to your
DocuPrint
96/DocuPrint 96MX LPS Operations Reference
chapter on HIP-
accessed communicating modes for additional information.)
HP2020 Selected host not present on system
The host selected is not available on your system.
Action Contact your systems specialist or Xerox representative.
HP2030 “ALL” not allowed at current logon level
HIP ONLINE ALL was entered, but the current LOGON level does
not support HIP ONLINE ALL.
Action None.
HP2090 Host interface must be online. Enter HIP ‘ONLINE’
or
Host interface must be online. select or enter ‘HIP ONLINE’
Host interface is not online.
Action Enter or select the HIP ONLINE command.
HP2100 Host file buffer full - enter HIP START
or
Host file buffer full - select or enter HIP START
The HIP STOP command was entered while the system was online.
Input continued transmitting files until the HIP buffer was full. Host
transmission has now stopped.
Action Enter or select the HIP START command to print files in the HIP
buffer.
HP2110 All jobs will be lost: confirm with ‘Y’.
The HIP ABORT ALL command was entered. This message is a
confirmation prompt.
Action 1. Enter Y to abort all jobs being processed.
or
2. If you do not wish to abort all jobs, enter N.