Laser Printing System Message Guide

HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-4 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
HP1130 Buffer file allocation less than specified
The HIP buffer has less space than specified in the HIP.CMD file at
installation. There may not be enough space to hold the entire job
being sent.
Action 1. Delete unneeded files from system disk to create more space.
2. Compress the disk. (Refer to your
DocuPrint 96/DocuPrint
96MX LPS Operations Reference
chapter on managing LPS
resources for additional information.)
3. Enter SETUP mode to change the HIP buffer file size. (Refer to
your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on HIP-accessed communicating modes for additional
information.)
4. Resend the job.
HP1140 Cannot abort job(s): xxxx (, yyyy, etc.)
The HIP ABORT jobs command was entered. The system is unable
to process the command because job(s) entered were not received
by printer.
Action 1. Verify that the job numbers were entered correctly.
2. Reenter the command.
HP1150 Cannot start job(s): xxxx
The HIP START jobs command was entered, but the system is
unable to process the jobs indicated because they are either not in
the pending or receive state, or they have already been started.
Action 1. Verify that the job numbers were entered correctly.
2. Reenter the command.
HP1160 Logging already enabled
You have entered the HIP LOG [START] command. The system is
informing you that the log is already enabled.
Action None.
HP1170 Log file allocation less than specified
The system is informing you that there is insufficient disk space in the
file system for the number of log entries specified in the LOG
ENTRIES command. The system allocates the largest possible
number of entries available for the disk space.
Action None.
HP1171 New log file created
A new log file has been created.
Action None.