Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-128 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS9460 Disk error - OCS. Call for service.
OS9500 Bad block on disk - Input. Call for service.
OS9530 Disk error - Input. Call for service.
OS9531 Disk error - Processing DJDE‘s.
OS9532 Disk write error - RTEXT File.
OS9537 Disk error or unable to open grid/index font.
OS9540 Unable to open a directory file.
OS9542 File xxxx error - Unable to create file.
OS9543 File xxxx error - Writing to disk file.
OS9550 Disk error - Output. Call for service.
OS9555 Disk I/O Error copying IMG File to Print File.
OS9556 Unidentifiable disk error copying IMG File to Print File.
OS9560 Font memory write error. Call for service.
An apparent fatal disk error occurred during the indicated process.
The job is aborted.
The printer control console displays:
OUTPUT STOPPED. SEE MESSAGE AT CRT.
Action 1. Restart the job. The message should not reappear if the failure
was an intermittent memory error.
2. If the failure recurs, a problem with the system disk is indicated.
Contact your systems specialist or Xerox Customer Service.
Note: CRT refers to the DocuPrint 96/DocuPrint 96MX LPS system
controller display.
OS9551 Unable to recover from disk error. Resetting system.
A system disk error has occurred that prevents printing from
continuing. To minimize data loss, a system RESET is being
performed.
Action In response to the RESET confirmation request, enter Y or press the
<ENTER> key. (Entering N to the confirmation request is not
supported.)
OS9700 Error detected while going offline.
A fatal error has been detected in the online interface when going
offline.
Action 1. Reboot the system by pressing the Boot button, then entering
B.
2. Enter the ONLINE, then OFFLINE commands again.
3. If the failure recurs, contact your systems specialist or Xerox
Customer Service.