Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-124 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS9103 Disk error with IPD message file, ETNMSG.SYS.
The system detected a read error the Interpress message file and
could not generate the job error summary; the error summary is
stopped at this point.
Action 1. If ETNMSG.SYS does not exist, sysgen or DSR restore to
recover ETNMSG.XYX.
2. If ETNMSG.SYS does exist:
a. RNAME ETNMSG.SYS to some well-known name (e.g.,
BADnnn.TMP).
b. Restore ETNMSG.SYS via a resysgen, if authorized to do
so, or contact your systems specialist (refer to your
DocuPrint 96/DocuPrint 96MX LPS System Generation
Guide
.)
c. Resend the job.
d. Contact your systems specialist or Xerox Customer Support
to log the bad sector and delete the well-known name.
OS9104 Disk error processing Interpress job errors (RTXFIL.SYS).
The system has detected a read or write error when logging or
printing a job error; the job is aborted at this point.
Action 1. If RTXFIL.SYS does not exist, DSR restore, sysgen, if
authorized to do so, or contact your systems specialist to
recover RTXFIL.SYS.
2. If RTXFIL.SYS does exist:
a. RNAME RTXFIL.SYS to some well-known name (e.g.,
BADnnn.TMP).
b. Restore RTXFIL.SYS via a resysgen. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS System Generation
Guide
.)
c. Resend the job.
d. Contact your systems specialist or Xerox Customer Support
to log the bad sector and delete the well-known name.
OS9200 Hardware error-input drive. Call for service.
A fatal error other than a read error has occurred. Due to the failure
mode, the data block in question cannot be recovered.
Action 1. If data loss is acceptable, press the <CON> key to resume
printing.
or
If loss is unacceptable, enter the ABORT job command to
cancel the job.
2. Restart the job.
3. If the problem continues, contact your systems specialist or
Xerox Customer Service and report SAN (Software Analysis
Number) 20.00.02.