Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-104 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS6780 Unsupported JDL option may jeopardize job integrity.
You have submitted a parameter in a DJDE or PDL command, such
as SESMAP or TRANS, which is not supported by 4050, 4090, 4650
printers. The appearance or position of your output may be affected.
Action 1. Check your output to see if it is satisfactory.
2. If the output is unsatisfactory, recode the JSL eliminating the
unsupported parameter.
OS6781 Unsupported DJDE option encountered. See OPRINFO Page.
A DJDE option was encountered which is not supported on this
printer.
Action Check OPRINFO page for unsupported option.
OS6782 Paper size exceeds printer capability.
In the PDL OUTPUT command you have specified a larger paper
size than the paper trays of the 4050, 4090, 4650 printers can
accommodate.
Action None.
OS6800 No XCS File specified for 850 job.
You have specified an invalid XCS file for 850 job.
Action Check your XCS file format.
OS6810 No XCS File specified for Ethernet Job.
“Volume Host = ENET” was coded in JDL, but .XCS was not entered
in document-name parameter of CWP,STA[RT] command. Job will
abort.
Action 1. Reenter CWP,STA[RT] command, including .XCS extension in
document name. (Refer to your Xerox LPS Reference Manual,
“Ethernet communications interface” chapter.)
2. Resend job.
OS6819 Improper file format. Record size is not 80 bytes.
The application has specified a disk-resident Ink List, but when the
file is accessed, it is found to be of the wrong format.
Action Check the application.
OS6820 Improper palette-name specification
The palette-name you have specified contains nonalphanumeric
characters and/or more than 32 characters.
Action Check the palette-name and retry the command.