Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-103
OS6754 Word processing merge job - switch codes missing.
During printing, a file was discovered to be incorrectly formatted, or
wrong switch code was entered in CCL MERGE command.
Action Resend job, correcting switch codes if necessary. (Refer to your
Xerox DocuPrint 96/DocuPrint 96MX LPS Reference Manua l,
“Communications interface” chapters.)
OS6755 Word processing merge job - no merge file.
There is no file name in XCS header for merge file.
Action Check your XCS file header packet.
OS6756 Word processing - document file I/O error.
Error has occurred in reading an .XCS file. Job cannot be processed.
Action 1. Resend job.
2. If message reappears, call Xerox Customer Support Center.
OS6757 Word processing - old XCS file - retransmit file.
Attempt was made to print a backup file containing a file header in an
obsolete format.
Action Resend job from workstation; do not use the old backup tape.
OS6758 Word processing file malformed. Retransmit file.
A start command was issued specifying an XCS file. The specified
file has an incorrect format.
Action Contact your systems specialist or Xerox Customer Support.
OS6760 Font char width table missing - word proc. aborting job.
An old (pre-V10 version) font file has been loaded. It cannot be used
for CWP jobs. Job is aborting.
Action 1. Restart job, using correct font tape.
2. Call Xerox Font Center for information on replacing font.
OS6761 Too many SEF Font mapping errors.
An exceedingly large number of Short Edge Feed font mapping
errors has occurred.
Action 1. Verify proper contents of mapping file and correct.
2. Rerun the job.