Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-81
OS Level 4: System or tape problem
States a problem and explains what action(s) to take.
OS4010 Cannot find end of tape reflector strip. ‘CONTINUE I’
The system did not encounter the End of Tape (EOT) label.
Action 1. Enter the ABORT I command to cancel the job.
2. Clean the magnetic tape drive to ensure read was accurate.
(Refer to the maintenance chapter in your
DocuPrint 96/
DocuPrint 96MX LPS Operator Guide
.)
3. Restart the job. If the message reappears, do one of the
following:
a. Enter the CONTINUE I command to resume processing. If any
“Label Error” messages appear, continue pressing the <CON>
key until the job prints.
Note: Check output for pages formatted incorrectly. You may
wish to recreate the job.
or
Enter the ABORT I command to cancel the job.
b. Check JSL and make any changes necessary. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations Reference
chapter on job control.
c. If there are no JSL errors, enter the START n, DUMP command
to obtain a tape dump for analysis.
d. Recreate the job, ensuring tape labels are correct. (Refer to your
Xerox LPS Tape Formats Manual .)
OS4050 Forms/Fonts/Graphics values are too large. Enter new values
via the Forms/Fonts/Graphics command
The command FORMS n, FONTS n, or GRAPHICS n was entered
with an n value greater than the system permits per job. (Maximum
allowable: fonts—128; forms—64; graphics—128.)
Action Reenter the command with a value within the acceptable range.
(Refer to your
DocuPrint 96/DocuPrint 96MX LPS Operations
Reference
chapters on using the font editor and using graphics, or
the
DocuPrint 96/DocuPrint 96MX LPS Forms Creation Guide .)
OS4100 Printer is in diagnostic mode. Call for service.
The printer is in a standalone diagnostic mode and cannot process
any communication.
Action Contact your systems specialist or Xerox Customer Service.