Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-67
OS2800 Move or space function complete.
The system has completed spacing over information on magnetic
tape as requested.
Action Enter the CONTINUE I command if the place where input is resuming
has the same JDE and JDL as before SPACE command was
entered.
or
If JDE/JDL are different than before the spacing function, enter the
CONTINUE command followed by a new JDE and JDL ID (CON
“jde,” “jdl”). (Refer to the offline chapter in your
DocuPrint 96/
DocuPrint 96MX LPS Operator Guide
.)
OS2810 Start-up message from Job Tape follows:
This message appears in a single report mode. A report delimiter or
forms information message will be displayed next.
Action Watch the printer control console display for a forthcoming
information message.
OS2811 The following is a document-generated “jobstart” message:
This is an informational message displayed prior to printing the job.
The actual “jobstart” message will follow.
Action None.
OS2812 The following is a document-generated “jobend” message:
This is an informational message displayed after the job has been
printed. The actual “jobEnd” message will follow.
Action None.
OS2820 Task not allowed till system status = ‘Idle’
The system must be offline and not printing to process the requested
task. The message also appears if the REWIND command is entered
or the Rewind button is pressed while a tape job is printing.
Action 1. Wait until the tape job completes before rewinding the tape.
or
2. Complete or abort any current jobs.
3. Enter the OFFLINE command.
4. Enter the desired command.
OS2822 Do a reset before retrying operation.
Your desired operation cannot be processed until the system has
been reset.
Action 1. Select Reset or enter the RESET command.
2. Retry the applicable operation.