Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-59
OS2570 Vary system offline at the host and enter ‘CONTINUE I’
or
Vary system offline at the host and select ‘CONTINUE I’
The OFFLINE command was entered.
Action 1. Follow procedures required to take the printer offline at your
host system.
2. Enter the CONTINUE I command.
OS2576 System rollover while online. CHeck host then enter ‘C’
or
System rollover while online. Check host then select or enter ‘C’
A software failure has occurred while the system is online. A rollover
has taken the system offline.
Action 1. Follow procedures required to take the printer offline at your
host system.
2. Enter C to initiate the automatic recovery procedure.
3. Follow recovery instructions on the display. (Refer to the online
chapter in your
DocuPrint 96/DocuPrint 96MX LPS Operator
Guid
e.)
4. After the recovery procedure is complete, resend any lost data
and enter the CONTINUE O command to resume printing.
5. If a software failure recurs, contact your systems specialist or
Xerox Customer Service.
OS2600 Tape volume out of sequence; mount correct volume
Magnetic tape label number detected by sensors does not follow
previous volume number.
Action Remove tape and mount volume that is next in numerical order.
(Refer to your
Xerox LPS Tape Formats Manual .)
OS2610 Improper ink-name list specification
The ink-name list you have specified does not conform to ink-name
list syntax. For example, you may have used double instead of single
quotes to identify the ink-names.
Action Check the specified ink-names and retry the job.
OS2611 More than 64 ink-names specified
The ink-name list you have specified contains more than 64 ink-
names, the system‘s limit.
Action Restructure your commands to contain a maximum of 64 ink-names.
OS2612 Invalid filetype for ink override file name
You have entered an incorrect override file-type. Only .TMP and
.MSC files are acceptable.