Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-51
OS2091 No available trays are ready
The tray(s) available for your job are not ready to be used. Possible
causes may be that they are empty, have the wrong type of stock, are
not properly latched, etc.
Action 1. Check the status of your trays, and correct as appropriate
2. Select different trays for the job.
OS2100 Main tray not ready
Feeder tray 1 has not risen completely.
Action Pull out the feeder tray and push it back in all the way. (The tray rises
automatically.)
OS2106 Enter ‘CONTINUE I’ when volume xx is mounted
or
Select ‘CONTINUE I’ when volume xx is mounted
Automatic job recovery was initiated after a system rollover while a
multivolume offline job was being processed.
Action 1. Load the tape volume number indicated.
2. Enter the CONTINUE I command to resume data transmission.
OS2150 Display (Y/N)?
This message asks you if you want relevant information to appear on
the system controller display.
Action Enter Y for yes or N for no.
OS2210 Bin x full.
The bin indicated in the message is full, thus causing the printer to
cycle down or preventing it from cycling up.
Action 1. Empty the bin.
2. Restart the job.