Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-48 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS2025 Remount volume n for next copy of report. CON I when ready.
This message appears when making multiple copies of multi-volume
reports in a noncollate mode. This includes reports with copy-
sensitive CMEs and multicopy reports that exceed size of print file,
necessitating hand collation.
Action 1. Reload the magnetic tape reel containing the volume number
indicated. (Refer to the offline chapter in your
DocuPrint 96/
DocuPrint 96MX LPS Operator Guide
.)
2. Enter the CONTINUE I command to resume input.
OS2030 Tape at EOV; ‘CONTINUE I’ will rewind tape.
The system has encountered the End of Volume label on the input
tape. (Because JSL contains the EOV = PAUSE statement, the tape
does not automatically rewind.)
Action Enter the CONTINUE I command to rewind the tape.
OS2035 Input stopped. Enter ‘CONTINUE I’ when host is ready. Input
stopped. Select ‘CONTINUE I’ when host is ready.
This message appears after a system rollover due to software failure.
It follows a message telling how far to back up the host.
or
The host has discontinued transmission. Automatic job recovery has
been initiated.
Action 1. Ensure that the current job is backed up the required number of
pages so no data is lost. (Refer to the online and offline
chapters in your
DocuPrint 96/DocuPrint 96MX LPS Operator
Guide
.)
2. Enter the CONTINUE I command to resume input.
OS2042 Check paper supply in Tray 3
Feeder tray 3 is out of paper or lowered.
Action Check the feeder tray and add paper if necessary.
OS2043 Check paper supply in Tray 4
Feeder tray 4 is out of paper or lowered.
Action Check the feeder tray and add paper if necessary.
OS2050 All appropriate trays are empty
There are no ready feeder trays in the feed source specified by the
data stream or the current FEED command.
Action Refill one or more feeder trays and press the <CON> key to resume
printing.