Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE 6-27
OS1380 Alignment is nn Scan Lines and nn Dots
Printed data will appear at the indicated number (76-260) of lines
from the top and bottom edges of paper, and the indicated number
(0-795) of dots from the right and left edges of paper.
Action None.
OS1381 Diagnostic alignment is x Scan lines and y Dots
For Xerox service personnel, this message provides alignment
information.
Action None.
OS1390 Invalid Scan or Dot value. Retry Align
The alignment number entered for dots or lines is not within the
permitted range.
Action Reenter the ALIGN command with value(s) within the range. (Refer
to the problem solving chapter in your
DocuPrint 96/DocuPrint 96MX
LPS Operator Guide
.)
OS1391 Invalid Scan or Dot value. Retry DAlign
For Xerox service personnel, this messages indicates that incorrect
alignment values have been entered.
Action None.
OS1400 Sample ignored...Printer idle
The <SAMPLE> key was pressed while the printer was not in the
process of imaging a page. The system could not produce a sample
page when the key was pressed.
The printer control console displays:
SAMPLE CANNOT BE PRINTED--PRINTER IS IDLE.
Action Continue pressing the <SAMPLE> key until sample page is
delivered.
OS1401 Sample ignored... already in progress
Your first request for sample(s) is being processed; your second
request is not accepted.
Action None.
OS1405 No files found to sample print
The system is unable to find file for the requested print sample on the
system disk.
Action Load the desired file to disk and reenter the SAMPLE
filename.filetype command.