Laser Printing System Message Guide

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-24 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS MESSAGE GUIDE
OS1296 There is no stockset specified at this time
The CLUSTER SET or CLUSTER SET N/R command was entered
but the collection of stocks to be used in the print job has not been
specified. (Refer to your
DocuPrint 96/DocuPrint 96MX LPS PDL
Reference
.)
Action Reprogram job to contain a stockset or wait until such a job is running
before entering this command.
OS1297 There are no current trays in any cluster
The CLUSTER command was entered but no clusters have been
defined.
Action Define the desired cluster. (Refer to your
DocuPrint 96/
DocuPrint 96MX LPS Operations Reference
chapter on setting up
print jobs for additional information.)
OS1298 Specified paper tray not present
A command was entered that refers to a feeder tray not in the printer
configuration.
Action Reenter the command, using a feeder tray that your system has.
(Refer to the chapter on feeder trays in your
DocuPrint 96/
DocuPrint 96MX LPS Operator Guide
.)
OS1300 Number of active forms is nn
The maximum number of forms per print job the system will attempt
to keep in forms memory is (number 0-64). This message appears at
installation when forms memory space is allocated.
Action None.
OS1310 Number of active fonts is nn
The maximum number of fonts per print job the system will attempt
to keep in memory is (number 0-128). This message appears at
installation when font memory space is allocated.
Action None.
OS1320 Number of active graphics is nn
The maximum number of graphics per print job the system will
attempt to keep in GHO memory is (number 16-128). This message
appears at installation when graphics memory space is allocated.
Action None.
OS1321 Print darkness level is nn.
After entering the DARKNESS command with a level parameter, this
message tells you that the value you have entered is accepted. If you
enter the DARKNESS command with no parameters, the message
tells you the current level setting.