User's Manual

FEEDER TRAYS
1-2 XEROX DOCUPRINT 96/4635/180 NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
• The printer does not feed all the paper out of a tray—
approximately 1/4 inch (6 mm) remains in the tray.
Loading feeder trays
It is important to load paper properly in the feeder trays to prevent
jams and loss of production time. The following guidelines will help
ensure maximum efficiency of your printer’s operation.
Guidelines for loading paper
When you are loading the paper, follow these guidelines to prevent
pager jams:
• Remove damaged sheets.
• Load the paper with the package wrapper seam side up.
• Make sure that the direction of the curl is consistent.
• Avoid fanning the paper unless the stock is predrilled.
• Do not load the paper above the MAX line on the length guide.
• Place any paper left in the bottom of the tray on top of the new
paper stack.
• For trays 3, 4, 5 and 6, load paper with curl side up. If you do not
detect paper curl, load paper with the wrapper seam side down.
Additional guidelines for loading special stocks:
• When loading predrilled paper, fan the paper and remove
loose paper plugs.
• Load transparencies into trays 1 and 2 only.
• When loading tab stock,remove deformed, bent, or damaged
stock.
• Loadpreprintedpaper in trays 3, 4, 5, and 6 only, in order not to
smudge the print. These trays are vacuum-type feeders, unlike
trays 1 and 2, which are friction-type.
Loading trays 1 and 2
Trays 1 and 2 are processor feeder trays.