Printer User Manual
Table Of Contents
- 96/4635/180/2000 Series NPS/IPS Guide to Performing Routine Maintenance
- Table of contents
- Safety
- Introduction
- 1. Feeder trays
- 2. Output trays and bins
- 3. Fuser agent
- 4. Adding dry ink
- 5. Replacing the dry ink waste container
- 6. Cleaning
- 7. Maintenance and support services
- Index
Cleaning
6-10 Guide to Performing Routine Maintenance
2. Observe the green LED blinking slowly to indicate that the
tape drive is automatically performing a cleaning cycle.
NOTE: If the cleaning cartridge has been used for more than
approximately 30 cleaning cycles, the amber LED will blink
rapidly. Press the unload button to eject the cleaning
cartridge and discard it.
3.
Remove the cleaning cartridge after it is automatically
ejected following the cleaning cycle.
You can use the cartridge tape drive immediately after cleaning.