Printer User Manual
Table Of Contents
- 96/4635/180/2000 Series NPS/IPS Guide to Performing Routine Maintenance
- Table of contents
- Safety
- Introduction
- 1. Feeder trays
- 2. Output trays and bins
- 3. Fuser agent
- 4. Adding dry ink
- 5. Replacing the dry ink waste container
- 6. Cleaning
- 7. Maintenance and support services
- Index
Replacing the dry ink waste container
Guide to Performing Routine Maintenance 5-3
5. Discard the waste material and container according to the
instructions on the label.
6. Slide a new, empty dry ink waste container into the printer
until it stops.
NOTE: Do not remove the cap from the container.
7. Close the printer doors.
8. Dispose of the dropcloth.
CAUTION
If any dry ink gets on your hands, wash them with soap and cold
water. Heat sets the ink permanently. If any dry ink gets on your
clothes, brush them with a dry paper towel or a stiff-bristled
brush. If this does not remove the ink, launder with detergent and
cold water. Tell dry cleaners that the spot is dry ink for a printer
so they do not use a solvent that sets the stain.