Printer User Manual
Table Of Contents
- 96/4635/180/2000 Series NPS/IPS Guide to Performing Routine Maintenance
- Table of contents
- Safety
- Introduction
- 1. Feeder trays
- 2. Output trays and bins
- 3. Fuser agent
- 4. Adding dry ink
- 5. Replacing the dry ink waste container
- 6. Cleaning
- 7. Maintenance and support services
- Index
Adding dry ink
4-4 Guide to Performing Routine Maintenance
1. Dry ink cartridge
2. Green handle
8. Hold the cartridge in place and pull off the paper seal.
9. Discard the seal along with the dropcloth.
10.Close the printer doors.
CAUTION
If any dry ink gets on your hands, wash them with soap and cold
water. Heat sets the ink permanently. If any dry ink gets on your
clothes, brush them with a dry paper towel or a stiff-bristled
brush. If this does not remove the ink immediately, launder with
detergent and cold water. Dry cleaners should be told that the
spot is dry ink for a printer, so they will not use a solvent that sets
the stain.
NOTE: Do not discard damaged, unused dry ink bottles. Return
the bottles to Xerox for exchange (for credit in the USA).
1
2