Printer User Manual
Table Of Contents
- 96/4635/180/2000 Series NPS/IPS Guide to Performing Routine Maintenance
- Table of contents
- Safety
- Introduction
- 1. Feeder trays
- 2. Output trays and bins
- 3. Fuser agent
- 4. Adding dry ink
- 5. Replacing the dry ink waste container
- 6. Cleaning
- 7. Maintenance and support services
- Index
Fuser agent
3-4 Guide to Performing Routine Maintenance
WARNING
If any fuser agent spills on the floor, remove it immediately.
Fuser agent spills make the floor slippery. Use of Xerox
Film Remover (isopropynal alcohol) is recommended to
clean up spills.
CAUTION
The fuser reservoir has an anti-splash seal. Do not push the
fuser agent bottle into the reservoir with excessive force, as this
can damage the seal.
7. Replace the reservoir cap by turning it clockwise and push
the fuser agent reservoir in until it stops.
8. Push the fuser drawer in until it latches in place.