Printer User Manual

Guide to Performing Routine Maintenance 3-1
3. Fuser agent
The fuser is responsible for fusing the print image to the paper
with heat. It is critical that the fuser be kept lubricated with fuser
agent and that its reservoir be kept full. This chapter describes
the procedure for adding fuser lubricant in the printer.
To add fuser agent:
1. Open the right and left doors of the printer and locate the
fuser area.
2. Place a dropcloth on the floor under the fuser area.
3. Grasp the green handle on the fuser drawer and pull it out
until it stops.