Printer User Manual

XEROX DOCUPRINT 96/4635/180 NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE 4-1
4. 4Adding dry ink
Dry ink is the black powder that forms the image on the printed page.
This chapter describes the procedure for adding dry ink to the printer.
Adding dry ink When the printer is low on dry ink, the Attention light turns on, and the
message ADD DRY INK displays on the printer console. Add dry ink
at your earliest convenience.
If you do not add dry ink, the printer eventually stops printing. It does
not resume printing until you replace the dry ink bottle.
Caution: If any dry ink gets on your hands, wash them with soap
and cold water. Heat sets the ink permanently. If any dry ink gets on
your clothes, brush them with a dry paper towel or a stiff-bristled
brush. If this does not remove the ink immediately, launder with
detergent and cold water. Dry cleaners should be told that the spot is
dry ink for a printer, so they do not use a solvent that sets the
stain.
Use the procedure on the following pages to add dry ink to your 96/
4635/180 NPS.