Printer User Manual

FUSER LUBRICANT
XEROX DOCUPRINT 96/4635/180 NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE 3-3
6. Remove the cap from a new bottle of fuser agent and carefully
pour the fuser agent into the reservoir, until the level reaches
the MAX line.
!
Warning: If any fuser agent spills on the floor, remove it
immediately. Fuser agent spills make the floor slippery. Use of
Xerox Film Remover (isopropynal alcohol) is recommended to
clean up spills.
Caution: The fuser reservoir has an anti-splash seal. Do not
push the fuser agent bottle into the reservoir with excessive
force, as this can damage the seal.
7. Replace the reservoir cap by turning it clockwise and push the
fuser agent reservoir in until it stops.