Printer User Manual

OUTPUT TRAYS AND BINS
2-2 XEROX DOCUPRINT 96/4635/180 NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
Checking and unloading high-capacity stacker (HCS) bins
The 4635 and 180 NPS printers can have up to four high-capacity
stacker (HCS) bins. The 96 NPS printer can have up to two high-
capacity stacker bins. Each high-capacity tray holds 2500 sheets of
20lb (80 gsm) paper. (Refer to System Overview for additional
information on the high-capacity stacker bins.)
If you use large paper sizes such as A3 or 11 x 17 inch, the stacker
may hold less than 2500 sheets. This is to ensure that the stack is at
a safe weight for lifting and unloading by the operator.
• You can lower, pull out, and unload any bin not currently in use,
without interrupting printing, as long as another HCS is ready to
receive paper.
• If you select a bin that is in use, the printer begins stacking in
the next defined high-capacity stacker bin if it is available. If no
stacker bin is available, printing stops.
• Once a sheet is delivered to a stacker bin, each subsequent
sheet must be within 25 mm (approximately 1 inch) of each
dimension of the first sheet.
Unloading a stacker bin
1. Select a bin for unloading by pressing the Bin Unload button on
the bin control panel. (You can also select the bin for unloading
through the printer mimic of the printer control console.)