Printer User Manual

PRINTERS
XEROX DOCUPRINT 92C NPS SYSTEM OVERVIEW GUIDE 3-3
9 Stop button
10 Fault code display
11 Information button
Attention light The yellow attention light glows whenever the system detects an
actual or potential problem.
• When the light is flashing, you should act immediately to
remedy situations. Typical problems are a pager jam or a full
waste container that have caused the printer to stop.
• When the light glows steadily, act soon to avoid a cycle-down. A
steady glow typically indicates that paper or dry ink is low.
Message display Printer status and simple operating and maintenance instructions are
shown in a two-line message. One of the following icons indicates the
printer mode:
Also in the lower panel, the dry ink color currently loaded is shown.
Graphic display The graphic display shows a specific area of the printer requiring
attention. The graphics help you locate the problem.
Wire percentage indicator If your printer has a stitcher/stacker, it displays the percentage of
stitcher wire remaining on the spool.
Feeder tray indicators These lights indicate the selected feeder tray or trays and the size of
paper loaded in each tray.
Power on/off switch This switch controls power to the printer and is used primarily by
service representatives.
Sample button Not used. The sample feature is not available on the 92C.
Continue button The Continue button resumes printing when it is pressed.
While it is formatting a complex page, the Printer Controller may
cycle down the printer if the page image is not available within a
certain time frame. If this occurs, the following message appears:
Press <CONTINUE> to resume printing
P
r
i
n
t
er
M
o
d
e
Black Highlight