Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE 48-35
J185 Stacker elevator fails to
reach new position.
The stacker elevator failed two successive attempts to
reach a new position.
No action required.
If problem persists, notify your service representative.
J188 Exposure level exceeded
target +
tolerance.
The laser exposure did not stabilize to the specified level
after power up, or the exposure level exceeded the
prescribed limits.
No action required.
If problem persists, notify your service representative.
J191 Pixel clock error or SOS/
EOS scan lines missing.
The pixel clock output malfunctioned.
No action required.
If problem persists, notify your service representative.
J197 SOS/EOS not balanced. The ROS intensity difference is not balanced.
No action required.
If problem persists, notify your service representative.
J198 Polygon motor assembly
producing extra scan
lines.
An extra scan pulse (EOS or SOS) occurred within the
scan window time limit.
No action required.
If problem persists, notify your service representative.
J213 PIXEL board VCO
voltage out of window
during print.
The VCO (Voltage Controlled Oscillator) voltage is not
within an acceptable range. If this fault occurs during
imaging, then a ROS PURGE will occur as well.
No action required.
If problem persists, notify your service representative.
J217 Interpolation overflow
detected.
There has been an error in the conversion of 300 dpi data
to 600 dpi data.
No action required.
If problem persists, notify your service representative.
J230 Dicorotron 1 fault. The charge 1 shield voltage or the charge 1 shield current
is out of tolerance.
No action required.
If problem persists, notify your service representative.
J232 Charge 2 shield voltage
at max.
The current charge value has exceeded 204 bits during
cycle up of xerographics.
No action required.
If problem persists, notify your service representative.
J246 Transfer assist blade
engage failure.
The transfer assist blade function failed to initialize
because solenoids did not engage while level two is NVM
enabled.
No action required.
If problem persists, notify your service representative.
Message Explanation/action