Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
48-34 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
J146 MIR self test input failure. There has been an MIR board failure or some input signal
line is shorted to ground.
No action required.
If problem persists, notify your service representative.
J147 MIR self test output
failure.
There has been an MIR board failure or an off-board
problem in the PHR output device or the signal line.
No action required.
If problem persists, write down the message and call your
service representative.
J148 XER self test output
failure.
There has been an XER board failure, an off-board
problem in some XER output device or signal line, or loss
of +15V to the XER board.
No action required.
If problem persists, notify your service representative.
J149 XER self test A/D failure. The failure may be caused by a XER board failure, an off
board problem affecting analog outputs such as
15V, or
a loss of some supply voltage to XER.
No action required.
If problem persists, notify your service representative.
J155 BFR self test input failure. There is a BFR board failure.
No action required.
If the problem persists, notify your service representative.
J156 BFR self test output
failure.
There is a BFR board failure.
No action required.
If the problem persists, notify your service representative.
J165 Stacker cover opened in
print.
The stacker cover is open.
Remove the paper and close the doors.
J169 FOR self test input failure. There is an FOR board failure.
No action required.
If problem persists, notify your service representative.
J170 FOR self test output
failure.
There is an FOR board failure.
No action required.
If problem persists, notify your service representative.
J176 Stacker offset fault. The stacker did not offset as specified; the mechanism
may be defective.
No action required.
If problem persists, notify your service representative.
Message Explanation/action