Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
48-32 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
H338 ESV2 drift fault. An ESV2 drift fault has been detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H340 Excessive charge loss
from charge dicorotron to
ESV1.
An excessive charge loss from charge dicorotron to ESV1
has been detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H341 Excessive charge loss
from ESV1 to ESV2.
An excessive charge loss from ESV1 to ESV2 has been
detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H344 Convergence timeout
(charge, BE mode)
possible photoreceptor
problem.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H345 Convergence timeout
(charge area) possible
photoreceptor or cleaning
problem.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H346 Convergence timeout
(charge, TL mode)
possible photoreceptor
problem.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H347 Convergence timeout
(modulated) ROS
modulated intensity at
maximum.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H348 Convergence timeout
(modulated) possible
cleaning problem.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H350 Convergence timeout
(discharge) ROS
discharge intensity at
maximum.
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H351 Convergence timeout
(discharge, discharge
area).
A convergence timeout has occurred.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H353 Electrostatic set-points
out of range, possible
massive cleaning
problem.
Electrostatic set-points out of range, possible massive
cleaning problem.
1. Press the Continue button.
2. If problem persists, notify your service representative.
Message Explanation/action