Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
48-30 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
H128 Toner waste bottle full. The dry ink waste bottle is too full.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H129 Patches for toner control
are out of range.
The process control patch used to control the toner
dispenser was returned as white, six times in a row.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H130 Ozone system failure. The ozone blower activation switch has failed.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H132 No process control
convergence after power
up.
The charge current is out of tolerance.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H133 Light patches; however,
toner bottle sensor
indicates presence of
toner in bottle/hopper.
1. Power the system off and back on.
2. If the problem persists, notify your service
representative.
H138 Failure to detect a
transition of waste or
reclaim auger in 3
seconds.
No action required.
If problem persists, notify your service representative.
H241 -
F4050
Set separator sensor or
solenoid failure.
A set separator sensor or solenoid failure has been
detected
1. Press the Continue button.
2. If problem persists, notify your service representative.
H241 -
F4850
XAN failed memory or
communications test.
The XAN has failed the memory test or the
communications test.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H304 Cleaner air pressure
indicates blockage.
A blockage in the cleaner has been detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H306 Black developer waste
tube blocked.
A blockage in the black developer waste tube has been
detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
H307 Color developer waste
tube blocked.
A blockage in the color developer waste tube has been
detected.
1. Press the Continue button.
2. If problem persists, notify your service representative.
Message Explanation/action