Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
48-10 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
Messages using Show Status
You can enter Show Status at the PS-op>-level to show a status of:
loaded paper sizes, printer messages, spooler, formatter, printing,
and queueing conditions.
Status messages appear in two ways. The first occurs automatically.
For example, if the top cover of the printer is open, you will see: “PS
E115 IOT top cover open”. If you enter Show Status, the same
message appears without the PS prefix.
Note: When the “SEE MESSAGE AT CRT” message is displayed
on the printer display panel, enter Show Status to see the status of
the Printer Controller and the printer. Afterwards, press the Continue
button on the printer.
In the case of “SYSTEM COMMUNICATION FAULT, SEE
MESSAGE AT CRT,” a Show Status may not display any printer
messages. This is due to the printer losing communication with the
Printer Controller and not reporting any appropriate messages.
A representative sample for the 4090 NPS follows:
PS-admin>Show Status
Printer Type: Xerox/4090, Duplex capable
Media Loaded:
A4::white: Tray 4
UsLegal::white: Tray 3
Not Set: Tray 2
UsLetter::white: Tray 1
Paper Trays:
1:OK (can feed: standard, transparencies, drilled)
2:Not Set
3:OK (can feed: standard, transparencies, drilled)
4:OK (can feed: standard, transparencies, drilled)
Stackers:
Top: OK, No Offset (can stack: standard, transparencies, drilled)
1: OK, Offset (can stack: standard, drilled)
2: OK, Offset (can stack: standard, drilled)
Stacker Groups:
0: Top Tray
1: Stackers 2,1
No Printer Messages.
Spooler status: Available
Formatter status: Available
Printer status: Available
Printing is Started.