Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE 48-27
F237 Finishing device offline. The finishing device is offline.
1. Discard the purged output.
2. Place the finishing device online.
F239 DFA set jam. DFA Set Delivery signal not received within the allotted
time.
1. Check the finishing device.
2. Press the Continue button.
F240 -
F4050
Set separator sensor or
solenoid failure
A Set Separator sensor/solenoid failure has been
detected.
1. Open the right front door.
2. Clear area 7 and close the right front door.
3. Press the Continue button.
F240 -
F4850
DFA delivery sequence
jam
The DFA Delivery signal is out of sequence.
1. Check the finishing device.
2. Press the Continue button.
3. If problem persists, contact your service
representative.
F242 DFA sheet jam. The DFA sheet did not arrive in the allotted time.
1. Check the finishing device.
2. Press the Continue button.
3. If problem persists, contact your service
representative.
F259 XAN lost machine clocks. The XAN lost its machine clocks.
1. Press the Continue button.
2. Discard the purged output.
3. If problem persists, contact your service
representative.
F260 XAN lost the pitch reset The XAN lost the pitch reset signal.
1. Press the Continue button.
2. Discard the purged output.
3. If problem persists, contact your service
representative.
F268 Black developer bias
voltage out of range.
The black developer bias is out of range.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
F269 Chopped black DC bias
voltage failure.
The chopped black DC bias voltage has failed.
1. Press the Continue button.
2. If problem persists, contact your service
representative.
Message Explanation/action