Network Printer Specification Sheet

PRINTER CONTROLLER MESSAGES
48-22 XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE
F068 HV power supply shut
down due to arc.
The power supply has automatically shut down.
1. Press the Continue button.
2. Discard purged output.
3. If problem persists, notify your service representative.
F083 Extra page in Finisher --
Remove top sheet in
Compiler Tray.
There is an extra page in the finisher.
Check the set delivered to the tray for the purged sheets
and remove them.
F084 Discard purge copies in
one bin stacker tray.
There are purged sheets in a stacker tray.
Check the set delivered to the tray for the purged sheets
and remove them.
F085 Purged prints in Bin 1 and
Bin 1 was the selected
output
There are purged sheets in Bin1.
Check the set delivered to Bin 1 for the purged sheets and
remove them.
F086 Fault code displayed in
standby after purging of
prints to Bin 2 if Bin 2 was
the selected output.
There are purged sheets in Bin 2.
Check the set delivered to Bin 2 for the purged sheets and
remove them.
F087 Machine not ready in 12
seconds.
A subsystem is not ready to print within 12 seconds.
1. Press the Continue button.
2. If problem persists, notify your service representative.
F089 Purged prints in Sample
tray and Sample tray was
the selected output.
There are purged prints in the sample tray.
Check the set delivered to the sample tray for the purged
prints and remove them.
F090 Fault code displayed in
standby after purging of
prints to unselected
output.
There are purged sheets in the output tray.
Remove purged sheets from the unselected output.
F122 Too few sheets in duplex
tray.
The set separator finger actuated the tray empty switch
before the required number of sheets were fed from the
duplex tray. This is usually caused by a multifeed out of the
duplex tray.
1. Discard unusable sheets.
2. If problem persists, notify your service representative.
F123 Duplex tray integrity fault
with cycle down. (Too
many/few sheets.)
An incorrect number of sheets was fed out of the duplex
tray (too many or too few). This is usually caused by a
multifeed into or out of the duplex tray.
1. Remove the indicated number of sheets from the
output. The sheets will be reprinted.
2. Discard the purged output.
3. Press the Continue button.
Message Explanation/action