Network Printer Specification Sheet

WINDOWS WORKSTATION MESSAGES
MESSAGES GUIDE 49-13
Failed to print the document. An LPR operation timed out
waiting for a response. Resend the job.
An LPR operation timed-out and the document failed to print. The
server to which you are printing may be down or the network may be
slow.
Source DocuPrint Print Submission software
Action Try to print the document again. If the problem persists, increase the
LPR printing time-out values (see the Windows XDS section of the
Guide to Submitting Jobs from the Client). If the problem persists,
contact your System Administrator to verify that the server to which
you are printing is available.
Feature conflicts have been found in the Job Ticket. Select the
Setup button.
The job ticket specifies printing options that are not supported by the
printer. The unsupported options have been reset to their default
values.
Source DocuPrint Print Submission software
DocuPrint print driver
Action Check the job ticket and either print the job with the default values or
assign new values. Contact your system administrator to verify the
available printing options for the printer you are using.
Finishing must be Single Portrait Staple, Slip Sheets or None
when paper stock lengths vary.
The finishing options you want to use are not available because your
specified paper stocks vary in length.
Source DocuPrint Print Submission software
Action Perform one of the following:
• Select any of the valid finishing options that are listed in the
message.
• Make your paper stock the same lengths.