Laser Printer Guide to Performing Routine Maintenance
XEROX DOCUPRINT 4850/4890 IPS GUIDE TO PERFORMING ROUTINE MAINTENANCE 3-1
3. 3Stitcher wire
The Wire Percentage indicator is located on the printer control
console of IPS systems configured with a stitcher/stacker. The
indicator displays approximate percentage of stitcher wire remaining
on the spool. Your service representative can set the display to flash
at a predetermined percentage as a warning that you are running low
on stitcher wire.
Figure 3-1. Stitcher wire indicator on the 4850/4890 printer
control console
Note: The percentage that displays on the wire percentage
indicator is an approximation and has a small margin of error.
When the stitcher spool empties, the printer stops, and you see the
following displays on the printer control console:
• The status display shows the fault code L152.
• The message window displays the following sequence of
messages, with the next message appearing each time you
press i:
— STITCHER IS OUT OF WIRE OR
SPOOL NOT ROTATING. PRESS i
— TRAINED OPERATOR CHECK WIRE
MANAGEMENT SYSTEM. PRESS i
— IF UNABLE TO FIX, PRESS CONTINUE
TO RESUME WITHOUT STITCHING
— STITCHER IS OUT OF WIRE
PRESS ’CONTINUE’ TO RESUME PRINTING.